Line jumps on curved connectors?

[agbvisio]

I've been struggling with getting line connectore to work. I just realized
that they don't seem to work with curved connectors. If I change back to a
right angle connector and move the connector slightly the line jumps show up.
But never for curved connectore, even if the PAge Setup-->LAyout and
RTouting --? appearance is set to curved.

Any clues?

[Paul Herber]

Post by agbvisio
I've been struggling with getting line connectore to work. I just realized
that they don't seem to work with curved connectors. If I change back to a
right angle connector and move the connector slightly the line jumps show up.
But never for curved connectore, even if the PAge Setup-->LAyout and
RTouting --? appearance is set to curved.

You are right, line jumps don't work on curved connectors. I don't think there is any way
round this.